background image

 

 

 

Before using your new heater, please carefully read through the following instructions. 

KEEP THIS BOOKLET IN A SAFE PLACE SO THAT YOU MAY REFER TO IT IN THE 

FUTURE. 

 

After removing the packaging, make sure that the heater is in good condition. 

 

Dispose of the packaging according to local guidelines if no longer needed. 

 

 

1. The heater should be mounted on the wall so that the air outlet is facing downwards. You 

must not install it vertically and it must be mounted level. 

Do not store or use any flammable materials or sprays in the vicinity of the heater. Do not 

cover the air outlet and inlet vents. 

2. If the electricity cable gets damaged it must only be replaced by a technician appointed by 

the  supplier.  This  will  avoid  possible  risks  and  ensure  that  special  tools  are  available  if 

needed. 

3. The heater must not be located immediately below an electrical socket. 

5. If the heater is not being used or you are repairing the heater, ensure that the heater is 

disconnected from the power supply. 

6. Do not touch the heater with wet hands. 

7. If the motor is not working properly, stop it immediately and notify the supplier. 

8. While using the heater, do not leave the door or window open otherwise it will influence 

the heating effect. 

9. When you turn off the heater, the fan will remain on for 30 seconds to allow the heater to 

cool down. After this time the heater will shut down. 

10. Using the remote you can set the programme. 

11. The remote control will only function with CR2025 batteries. 

12. At the end of 

the heater’s working life, the remote battery must be removed before it is 

disposed of. 

13. All batteries must be disposed of following local guidelines. 

14. The heater must be installed at least 2m above the floor. 

15. In case of breakdown or damage turn off the appliance at the main On/Off switch and 

notify the supplier. 

16.

 This appliance is not intended to be used by persons (incl. children) with limited physical, 

sensory or mental capabilities, or who lack experience, except for those under supervision 

or who have received instruction in the use of the appliance from a person responsible for 

their security. 

17.

 Children must be supervised in order to ensure that they do not play with the appliance. 

18. 

CAUTION

 

—some  parts  of  this  product  can  become  very  hot  and  cause  burns. 

Particular attention has to be given where children and vulnerable people are present.

 

 

 

 

 

1.  INTRODUCTION 

2.  IMPORTANT SAFETY INFORMATION 

Summary of Contents for M-28 Downflow












Reviews: