14
OPERATION
How to Stop Engine
• Turn the Economy switch to the “OFF” position.
• Disconnect any electronic device. All loads MUST be disconnect from the generator. Never start or stop the engine
with electrical devices plugged in to the sockets.
• Turn the Start Switch to the “OFF” position.
• Turn the fuel supply to the “OFF” position.
Standard Atmospheric Conditions
Ambient Temperature: :25ºC
Barometric Pressure: 100kPa
Relative Humidity: 30%
Generator output will vary due to changes in temperature, altitude and humidity. If the temperature, humidity, or
altitude are higher than standard atmospheric conditions, the generator’s output will be reduced. The load
attached to the generator must therefore be reduced.
How to Attach Electronic Devices
1. Before Starting generator
• Make sure the generator is grounded (see page 10 for instructions).
• Make sure the attached load is within the generator rated output and the receptacle’s rated current.
• Make sure all electrical cords and sockets are in good condition.
• Make sure all electronic devices are turned OFF before plugging them into the generator.
2. Start engine
3. If the attached load is small, turn the ECONOMY switch to the “ON” position. For a larger load, or if attaching multiple
electronic devices turn the
Economy
switch to the “OFF” position.
4. Make sure the green AC pilot indicator light is on.
.
6. Allow generator output to stabilize (engine and attached devices run evenly) before plugging in the next load.
• Start the engine and let it stabilize before connecting any electronic devices.
• Disconnect all electronic devices before stopping the engine.
Never start or stop engine with electrical devices plugged in to the receptacles. Failure to
do so could damage the generator and / or connected electrical devices.
WARNING!
