Dualsky Hornet 460, Instruction Manual

Page: 16 / 24

- 16 -
4
Configuration
设定与调试
Transmitter Setting
遥控器设置
Futaba JR Spektrum
AIL
ELE
THR
RUD
NOR
REV
NOR
NOR
NOR NOR
NOR
REV
REV
REV
REV
REV
HOTT
D/R SW NOR REV NOR
NOR
NOR
REV
REV
REV
· 双天H460四旋翼需要一台四通道或以上的遥控设备；
· 如果您使用五通道或以上的遥控器，请将 CH5 连接至三段或两段开关通道，并将该
开关拨至最小。该通道用来调节飞行过程中操纵杆的灵敏度。如果使用四通道遥控器，
操纵杆灵敏度可在飞控中设定；
· 设定遥控器为固定翼模式，如果遥控器有混控功能，请关闭所有混控，将各通道行程
都设为100%；
· 各通道的电子微调（TRIM或SUBTRIM菜单）和摇杆的机械微调都归“0”；
·如下图所示，根据品牌设定遥控器各通道正反向。
· The Hornet 460 needs a 4-channel or higher radio controller to operate;
· If you are using a 5-channel or higher radio controller, please connect
the CH5 to 3-position or 2-positon switch channel, and set the switch
to Min. This channel is used to adjust the sensitivity of sticks. If you
are using a 4-channel radio, you can adjust the sensitivity on the FC430;
· Set the radio to “Airplane Mode”, turn off all the mixing functions,
set all channel’s D/R to 100%;
· Set all channel’s trim, sub-trim and mechanical trim to “0”;
· Set all channel’s direction according to the below chart.
ESC Initial Setting
电调行程设定
· Turn on the radio controller, push the throttle stick to the top, turn
on power to the Hornet 460, when L1 shows blue in color, it means
the ESC is in initial setting mode;
· Wait until the ESC's long beep (it means the top point of throttle has
been confirmed), then pull the throttle stick to lowest point;
· Wait about 1 second for a short beep (it means the lowest point of
throttle has also been confirmed), the ESC initial setting is finished;
· Don't move the throttle stick after initial setting, turn the power off to
the Hornet 460, then reconnect the power after 5 seconds, the new
setting will be applied.
· 开启遥控器，将油门推至最高，接通四旋翼飞行器的电源，L1蓝灯亮时，即进入电调
行程设定模式；
· 等待电调发出“滴”声（长声），表明油门最高点已经确认，此时应立即将油门收至
最低；
· 等待约1秒，电调再次发出“滴”声（短声，约0.2秒），表明油门最低点确认，即完
成电调行程设定。电调设定完成后请勿推高油门（为确保安全，建议断开电源后重新
接通）。