- 17 -
·
按键操作说明:
1.锁定状态下长按(大于两秒):进入设定模式
2.设定状态下单击:改变设定项
3.设定状态下双击(双击有效间隔小于0.5秒):改变该项设定值
4.设定状态下长按:保存并退出
·
具体设定项如下表所示
·
“SET” Button usage:
1)
Long Press
(more than 2 sec) under Lock Mode:
enter Setting Mode
2)
Single Click
under Setting Mode:
switch between SETTING ITEM
3)
Double Click
(finish within 0.5 sec) under Setting Mode:
change SETTING VALUE
4)
Long Press
(more than 2 sec) under Setting Mode:
Save and Quit
to Lock Mode
·
Please check the below chart for all settings.
· Some settings will take effect after the Hornet 460 is restarted. Cut the power to
the Hornet 460 and reconnect after 5 seconds to apply the new settings.
·
部分设定需重启飞控后才能生效,因此在飞控设定完成后,请断开
四旋翼飞行器的电源,稍等5秒钟再重新接通电源以应用新的设定值。
Flight Control Setting
飞控设置
·
How to enter Setting Mode:
Turn on radio controller, move the throttle to lowest
position; turn on power to the Hornet 460, wait until the L1 LED finishes flashing
Green and then changes to RED (Now the flight control is in Lock Mode); press
the “SET” button on the flight control to enter Setting Mode. After you enter Setting
Mode, L1 displays the corresponding SETTING ITEM menu attributes (color),
and L2 displays the corresponding SETTING VALUE menu attribute (color).
·
如何进入设定模式:打开遥控器,油门收至最低,接通四旋翼飞行
器的电源,等待飞控L1绿灯闪烁结束红灯常亮(此时为锁定状态)
后,长按飞控上的“SET”按钮进入设定模式。此时,L1的颜色指示
设定项目,L2的颜色指示该设定项当前设定值。
L1
Setting Item
设定选项
D/R
杆量
ESC PWM Freq.
电调PWM频率
Gyro Direction
陀螺仪方向
Potentiometer Lock
电位器锁定
Factory Reset
恢复出厂设置
Blue
蓝色
Green
绿色
Red
红色
Yellow
黄色
White
白色
L2
Min.
小
400Hz
Front face upward
正面向上
Not Lock
未锁定
Reset
恢复设置
Mid.
中
200Hz
Back face upward
背面向上
Lock
锁定
Max.
大
266Hz
Front face to left
正面向左
333Hz
Front face to right
正面向右
Blue
蓝色
Green
绿色
Red
红色
Yellow
黄色
Setting Value
设定值
* Blue color setting indicates default values
*
蓝色设定值是默认值
ALL SETTINGS ARE OPTIMIZED TO FIT HORNET 460, DON’T CHANGE THEM UNLESS IT’S NECESSARY
.
设定项目根据双天H460已做最优化处理,如非特殊情况无需设定。
!
Attention
注意