Universal Drinking Water Series
8
V4.3D
3
7
4
INSERT
FERRULE
NUT
KITCHEN FAUCET
HOT WATER
VALVE
COLD WATER
VALVE
D
A
INLET
OUTLET
9
A
INLET
OUTLET
D
3
STEP
3
Disconnect the cold water line from the 1/2” threaded stub on the bottom of the kitchen faucet.
4
Connect the kitchen faucet adapter to the kitchen faucet stub.
5
If you have a rigid plumbing pipe, it may be necessary to shorten the pipe. Remove any burrs with a metal file.
STEP
2
Install the Kitchen Faucet Adapter (Not Included) (continued)
6
Connect the cold water supply line to the kitchen faucet adapter securely.
Be sure that all electrical appliances and outlets are turned off at the
circuit breaker before working in the cabinet area.
WARNING
Please wear safety glasses to protect eyes when
drilling.
CAUTION
STEP
3
Connect Water Lines
1
Determine the length of 1/4” Plastic Tubing D that will be necessary to connect the System Head Inlet to the kitchen faucet adapter.
Make sure to allow enough tubing to prevent kinking in the line.
2
Cut the tube squarely on both ends.
3
Wet one end of the 1/4” Plastic Tubing with water and push it into the kitchen faucet adapter approximately 5/8” until it stops.
NOTE: Do not bend or crimp 1/4” Plastic Tubing when inserted.
4
Wet the other end of the 1/4” Plastic Tubing with water and push it into the System Head Inlet approximately 5/8” until it stops.
5
Determine the length of 1/4” Plastic Tubing that will be necessary to connect the System Head Outlet to the threaded faucet for filtered
water. Make sure to allow enough tubing to prevent kinking in the line.
6
Cut the tube squarely on both ends.
7
Gently slide the plastic compression nut down (thread side up) over the 1/4” Plastic Tubing. Follow with the plastic ferrule, making sure
that the ferrule is in the proper position with the larger opening on the bottom (going into the nut). Place the plastic insert into the end of
the 1/4” Plastic Tubing.
8
Firmly push the 1/4” Plastic Tubing into the end of the threaded faucet stem. Hand-tighten the plastic compression nut onto the threads.
Tighten with an adjustable wrench approximately 1/2 turn.
NOTE: Do not bend or crimp 1/4” Plastic Tubing when inserting. Do not over tighten the compression nut.
9
Wet the other end of the 1/4” Plastic Tubing with water and push it into the System Head Outlet approximately 5/8” until it stops.
