DTS X-BRICK, User Manual, Page: 15 / 60

15
9.1 DMX addresses
X-BRICK can be used in 9 DMX modes:
1. Standard (10 ch)
2. Chase (23 ch) (Default)
3. Extended (29 ch)
4. Global RGBW (4 ch)
5. Global RGBW + Shut + Dim (6 ch)
6. Global RGBW + Dim Fine (10 ch)
7. Sectors RGBW X4 (16 ch)
8. Sectors RGBW Fine X4 (32 ch)
9. Sectors RGBW + Shut + Dim X4 (24 ch)
DMX Full Operation modes
- Chase (default)
- Extended
- Sectors RGBW X4
- Sectors RGBW Fine X4
- Sectors RGBW + Shut + Dim X4
DMX Single Layer modes (compatibility with all BRICK models)
- Standard
- Global RGBW
- Global RGBW + Shut + Dim
- Global RGBW + Dim Fine
In order to use the unit in
“Chase” mode (23 DMX channels) (Default), set the following
addresses on the mixer:
Projector 1 A001
Projector 2 A024
If you want to select the next projector,
just add “23”
Projector 3 A047
…..
A….
projector 6 A116
9.2 Selecting the DMX address
1) Press the UP-DOWN key until you reach the required DMX address. The numbers
on the display will start to flash (but the new DMX address hasn't yet been set).
2) Press ENTER to confirm your selection. The numbers on the display will stop
flashing and the projector is now controlled by the new DMX address.
TIPS: if you keep pushed the UP or DOWN keys, the channels are calculated more
quickly and you get a faster selection.