9
To master delete all codes
Press and hold the K1 learning button, the LED will flash 10 times, all transmitter codes held in the
memory have been erased.
Wiring for external receivers.
PCB to Receiver
+24 24 Volt
- Neg.
+A N/O
A Com.
(Power for any 24 volt DC externals can also be taken from SP- (Neg.) and SP+ (Pos.)
(If the receiver and the cover red push button don’t work, power down for approximately 5 seconds then re-apply
power).
N.B.: If a transmitter is lost or stolen please master delete the receiver and re-learn all the
transmitters again.
OWNER’S MANUAL
DOOR OPERATION
A roller door equipped with a roller door operator may be operated by any of the following two
methods:
By using the hand held Transmitter;
By depressing the push button on the control box. (Mounted on the wall)
WARNING!
Ensure that the Centre Lift Lock is not engaged when the Drive Unit is in the automatic position.
Manual Operation
In the case of a power failure, the drive unit has an easily accessible manual release lever; the door
could be opened manually.
Obstruction Detection
During an open cycle if an obstruction is detected the door will stop.
During a closing cycle if an obstruction is detected the door will reverse to the open position.
The sensitivity or the amount of force required to cause an obstruction detection is fully adjustable.
Courtesy Light
An internal courtesy light is housed within the control box enclosure. This is activated during an
open or close cycle and will stay illuminated for approximately 60 seconds.
Automatic Closing.
When auto close is selected, the door will close after 60 seconds. Please do not use this function
without installing Photo-beam.
Photo-electric sensor
The operator includes an interface for the connection of a photo-beam sensor.
The Photo-beam sensor can be supplied as an accessory option.
OPERATING CONTROLS
a.
Control Box Push Button
Pressing this button will open, close or stop the door.
b.
Hand transmitter
Pressing the programmed transmitter will open, close and stop the door.
The hand transmitter is manufactured using the latest surface mount technology and incorporates 4
functional buttons. This enables the user to remotely control up to 4 separate operators from the
one transmitter.
