4
Gearbox mounting instructions
1.
Fit gearbox over mounting bolts protruding from base plate.
2.
Slide gate fully open and closed, insuring pinion gear has approximately 5mm clearance to gate at
all times.
3.
Fasten gearbox down firmly to base plate using M10 washers and nuts.
How to override the gate motor for manual operation
1.
Unlock and open the override lever on the gearbox.
2.
The gate can now be opened and closed manually.
Rack mounting instructions
1.
Unlock and open manual override lever fully to disengage gearbox. (See above).
2.
Using a 2.5 to 3mm spacer between the pinion gear and the rack, mount the rack
using Tek screws No12x20 (not provided) and screw the rack to the gate starting
from the tail of the gate and ensuring that the rack is mounted level.
(A 2.5 to 3mm spacer can also be put between motor and base plate when fitting rack. This must be
removed once the rack is in place).
NB
:
Ensure that one of the screws attaching the nylon rack to the angle is in line with the
read switch or limit switch spring when the gate is fully closed and open position.
Limit switch actuator mounting instructions
1.
Remove the screw attaching the nylon rack to the angle that is closest to the position of the reed
switch or the spring on the motor when the gate is in the close and open position.
2.
Fit limit switch actuators with screws provided onto the nylon rack.
3.
Setting the gate close actuator – Close the gate with approximately 10-20mm gap between gate and
close stopper. Now move the actuator until the close LED lights up. Fasten the actuator.
4.
Setting the gate open actuator – Open the gate with approximately 10-20mm gap between gate and
open stopper. Now move the actuator until the open LED lights up. Fasten the actuator.
5.
(The gate must never bump against the close or open end stoppers).
Magnetic limit actuator Spring limit actuator
Important:
For safety reasons, a solid stop must be fitted at
both ends
of the gate to prevent the gate
from moving past its full open or close position.
