DTM System miniR2 Series, Assembly And Operating Manual, Page: 27 / 32

4
PRESS 2 BUTTONS
OF REMOTE WITH
GALACTIC CODE
REMOTE WITH GALACTIC
CODE
5
G LED BLINKS 3 TIMES
- THE CODE IS ENTERED
x3
6. Removing of the Galactic authentication code from the controller (available only for the
miniR2 868 version).
To remove the authentication code, you must have a remote control with the Galactic function that you
entered the code with.
To remove the authentication code:
Ÿ
press buttonC1 to light theG diode
Ÿ
press and hold C1, release the button when the G diode starts to
fl
ash The G diode will
fl
ash for 8
seconds.
Ÿ
during this time, press two buttons on the remote control, with which the code was entered, for 5
seconds.
TheGalactic authentication code is removed after the controller is formatted.
7.Adding a remote with theGalactic function (available only for the miniR2868 version).
The condition of successful adding of the remote control with the Galactic function to the controller is the
compliance of the authentication codes set in the controller and the remote control.
To add a remote control, press and hold any two buttons on the remote control for 5 seconds.
Failed adding of the remote control can be caused by:
Ÿ
the controller and transmitter authentication codes do not match,
Ÿ
low battery of the remote control,
Ÿ
radio interference that may have occurred during the procedure for entering the remote control,
Ÿ
the controller's memory full.
Fig.9 Adding a remote control with the Galactic function.
Fig.8 Entering / removing the GALACTIC authentication code.
1 2
IN CONTROLLER
RADIO RANGE
PRESS AND HOLD
FOR 5 SECONDS
TWO BUTTON OF REMOTE
5s
1 2
3 PRESS THE C1 BUTTON
TO LIGHT THE G LED
LED G WILL PULSE
FOR 8 SECONDS
HOLD C1 RELEASE C1
WHEN G LED PULSE
EN