DTM System miniR2 Series, Assembly And Operating Manual, Page: 24 / 32

1
6
2
7
3 4
PRESS BRIEFLY C1
PRESS REMOTE
BUTTON
OP LED LIGHTS UP
LED ONCE FLASHES
THEN OFF IT GOES
- ADDING SUCCESSFUL
PRESS BRIEFLY C1
TO CHOOSE FUNCTION
PRESS AND HOLD C1
CONTROLLER PROGRAMMING
Before starting programming, refer to Fig. 1 showing the controller view to locate the programming
buttons C1 and C2 and the LEDs.
The controller automatically exits the programming menu after 30 seconds of inactivity.
1. Adding a remote control button to the function.
Adding a remote control to the controller consists in adding a button to the function:
OP - OPEN - OPENING
CL - CLOSE - CLOSING
STOP - STOP - STOP
SBS - STEP BY STEP - STEP BY STEP
Ÿ
To assign a button to one of the controller functions or change the function assigned to a given
button to another function:
Ÿ
enter the programming mode of the remote control button by brie
fl
y pressing the C1 button.
Entering the button programming mode is signaled by lighting of the OP diode.
Ÿ
by brie
fl
y pressing the C1 button select the function. The selection is indicated by the LEDs on:
OP - opening, CL - closing, STOP - stop, SBS - step by step
Ÿ
press and hold the controller button C1, the LED of the selected function will start blinking, at
this moment press and hold the button of the remote control which is to be added to the
function. Successful adding is indicated by blinking and then the function LED goes o
ff
.
Fig.4
Assigning a remote control to the function.
5
LED OF SELECTED
FUNCTION STARTS
BLINKING
EN