DTM System miniR2 Series, Assembly And Operating Manual, Page: 25 / 32

2. Deleting a single remote control from the controller memory.
To remove a remote control:
Ÿ
simultaneously press and hold controller buttons C1 and C2, all LEDs will start blinking,
Ÿ
then press the button on the remote control to be removed. Successful removal of the remote
control is indicated by the LEDs going o
ff
.
Holding the C1 and C2 buttons for too long will format the controller memory!
3. Remote adding of the remote control into the controller memory.
The remote adding function allows you to add a remote without having to physically access the controller.
The condition of success is the necessity of being within the radio range of the controller and having the
previously entered remote control.
To add a remote control remotely:
Ÿ
within the receiver range, press the button of the already added remote control for 15 seconds.
Ÿ
during no more than 3 seconds, press and hold for 15 seconds the button of the remote control to be
added. The "new" remote will be added with the con
fi
guration of the "old" buttons used in the
procedure.
The remote adding feature is not available if:
Ÿ
settings of controller work in momentary mode,
Ÿ
the remote adding lock turned on.
Failed registration of the remote control can be caused by:
Ÿ
weak battery of one of the remote controls,
Ÿ
radio interference that may have occurred during the remote adding procedure,
Ÿ
the receiver's memory full.
The remote adding function is only available for DTMSystem remote controls.
Fig.6 Remote adding of the remote control.
Fig.5 Deleting a single remote control.
1 2 3
PRESS AND HOLD
C1 AND C2
LEDS START BLINKING
PRESS REMOTE BUTTON
LEDS GO OUT
- DELETING SUCCESSFUL
1 2 3 PRESS THE 'OLD' REMOTE
BUTTON FOR 15 SECONDS
AFTER UP TO 3 SECONDS
PRESS THE 'NEW' REMOTE
BUTTON FOR 15 SECONDS
REMOTE IN CONTROLLER
RADIO RANGE REMOTE IN CONTROLLER
RADIO RANGE
EN