13
programmed remote control), if necessary disarrange servomotor and close the gate manually, next arrange
again.
- make sure that there is no obstacle in the way of photocells barriers, and on the way of the move of the gate,
- press and hold LEARN button up to the moment when LEARN diode goes on (after about 3 seconds)
- press LEARN button shortly again (for learning you can use instead of LEARN button any OPEN A, OPEN B,
OPEN C button or remote control button programmed on the radio card) begins slowed movement of the first
leaf towards opening. From this moment only this chosen button will be used in the learning procedure.
- second pressing – leaf 1 increases speed to standard opening speed
- third pressing – leaf 1 is slowed down
- fourth pressing – leaf 1 stops
- fifth pressing – leaf 2 starts slowed move towards opening
- sixth pressing – leaf 2 increases speed to standard opening speed
- seventh pressing – leaf 2 is slowed down
- eighth pressing – leaf 2 stops
- ninth pressing – leaf 2 starts slowed move towards closing
- tenth pressing – leaf 2 increases speed to standard closing speed
- eleventh pressing – leaf 2 is slowed down
- twelfth pressing – leaf 2 stops
- thirteenth pressing – leaf 1 starts slowed move towards closing
- fourteenth pressing – leaf 1 increases speed to standard closing speed
- fifteenth pressing – leaf 1 is slowed down
- sixteenth pressing – leaf 1 stops and the procedure is finished, LEARN LED diode goes off.
In order to set the zero time of slowing down, it is necessary to press learning button again for less than 1
sec during slowed movement of control unit. Respectively to programme the delay phase it must last at least 1
sec.
CAUTION!
Disturbing photocells while learning, won't cause stopping of the servomotor! If needed, it is possible to
stop the move of the gate with manual steering STOP button. It will also interrupt learning operation and
restore all parameters the work of the control unit to the values as before initiating the learning function.
During the procedure photocells barriers should not be disturbed and it is necessary to provide free move of
the gate, without any obstacles on its way.