DTM Print LX 3000e, User Manual

Page: 20 / 65

16
Max Min
Label width 8.25" (210mm) 0.5" (13mm)
Liner/media width 8.375"
(213mm) 1.5" (38mm)
Label height/length 24" (609mm) 0.5" (13mm)
Gap between labels 10" (610mm) 0.10" (2.5mm)
Width of through-hole
opening 0.5"
(12.65mm) 0.25"
(6.325mm)
Gap Sensor Adjustment
Range (from left edge) 1.9" (48mm) 0.20" (5.06mm)
Reflective/Black
Mark Width* N/A 0.1" (2.54mm)
Max Outer Diameter
(OD) 6.0"(152.4mm) N/A
Inner Core Diameter
(ID) 3.0" (76.2mm) 3.0" (76.2mm)
Total Thickness .0010” N/A
(Liner + Label)** (10 mil)
Distance from edge of This assumes a 2 mm gap.
media to edge of label
However, this is adjustable via
the left margin offset.
* The Reflective/Black Mark should be opaque to infrared light. The mark should be
between the labels. The end of the mark should correspond with the beginning of the
label.
** This is the recommended maximum. There are two factors that determine whether
the printer will accept any particular stock thickness.
1.
The ability for the printer to pull the paper through the print area.
2.
The ability for the sensor to read through the backing if the sensor is set to die-cut.
If you are printing in continuous or reflective label sensing mode number 2 does not
apply. The fact that the printer must read through the backing in die-cut mode will limit
the thickness much more than the printer's ability to pull the paper through the print
area. However, if you adjust opacity level of the liner enough to allow the label to be
seen by the stock sensor, the thickness will only be limited by the printer's ability to
pull it through the printer area. For these reasons the weight or thickness of the liner is
a variable that cannot easily be defined. DTM Print recommends and uses 40# liner
with all label stock.
It is important to test all label stock with the intended printer
before ordering large quantities!