7
QUICK START Option 2
Using A Separate Micr
Using A Separate Micr
Using A Separate Micr
Using A Separate Micr
Using A Separate Microphone with the
ophone with the
ophone with the
ophone with the
ophone with the
Noodle Antenna
Noodle Antenna
Noodle Antenna
Noodle Antenna
Noodle Antenna
NOTE: The channel being used must be programmed
to use the internal mic
.
1
Install the 36” remote microphone into the auxiliary
(multi-pin) connector on the transmitter
2
Install the noodle antenna into the antenna connector
on the transmitter. Adjust length to center of operating
frequencies. (See example on Page 22)
NOTE: This is a push-on, push off locking connector.
The connector will rotate 360° in the transmitter without
disconnecting. Use extreme caution when connecting
or removing the noodle antenna.(See illustration on
page 12.)
3
Ensure that the power switch on the transmitter is set
to OFF. (Red dot is OFF).
4
Slide the battery door to the right and install six, fresh
AAA batteries, being careful to observe proper polarity.
Slide the battery door to the left to close the battery
compartment.
5
Using a small screwdriver, turn the recessed rotary
switch located on the front cover to the desired
channel.
6
Turn the unit on by sliding the switch to the ON
position.(Green dot is ON.)
NOTE: Do not operate
the transmitter without
an antenna installed.
