6
QUICK START Option1
Using The Antenna/Mic Assembly
Using The Antenna/Mic Assembly
Using The Antenna/Mic Assembly
Using The Antenna/Mic Assembly
Using The Antenna/Mic Assembly
NOTE: The channel being used must be programmed
to use the antenna/mic
1
Install the antenna/mic into the antenna connector
on the transmitter.
NOTE: This is a push-on, push off locking connector.
The connector will rotate 360° in the transmitter
without disconnecting. Use extreme caution when
connecting or removing the mic/antenna.(See
illustration on page 12.)
2
Ensure that the power switch on the transmitter is set
to OFF. (Red dot is OFF).
3
Slide the battery door to the right and install six, fresh
AAA batteries, being careful to observe proper polarity.
Slide the battery door to the left to close the battery
compartment.
4
Using a small screwdriver, turn the recessed rotary
switch located on the front cover, to the desired
channel.
5
Turn the unit on by sliding the switch to the ON
position. (Green dot is ON.)
NOTE: Once power is applied (after approximately 3
seconds), the Status LED will turn on (green), which
indicates a successful self-test. The LED will turn off
after a few seconds.
NOTE: Do not operate
the transmitter without
an antenna installed.
