DSX Access System, Inc. algo 8028, Manual

Page: 12 / 31

|
Algo 8028 SIP Doorphone
| 12
3.
Enter the following in the
SIP
screen and click
Save
when you are done:
a) SIP Domain : The IP address of the DSX.
b) Extension : The IP extension number of the doorphone (e.g., 401).
c)
Authentication ID
: Same as above (the IP extension number of the doorphone).
d) Authentication Password : The password for the IP extension number as entered in the DSX. See 2106-02:
Password [Stations: Config: Setup: VoIP: Password] on page 28 for more.
e) Dialing Extension : 301 (This required entry can be any extension since the entry is ignored by the DSX.)
4.
Click
Basic Settings: Door Relay
to access the
Door Relay
screen. You see::
5. Make a note of the following entries on this screen. You may have to return to it later on.
a)
Momentary Open Code (6 by default)
b) Latch Open Code (no default entry)
c) Latch Closed Code (no default entry)
6. Click
Logout
to log out of the Control Panel and return to the opening screen.
2. In DSX programming, set the circuit type, password, and DTMF Type for the doorphone IP
extension.
1.
2101-01: Station Type [Stations: Config: Setup: Type (2101): Type] on page 26
The doorphone circuit type is 10, the same as the traditional analog doorbox.
2.
2106-02: Password [Stations: Config: Setup: VoIP: Password] on page 28
Enter the same password you entered above in the Algo
Authentication Password
option.
Option Description
Password Extension password, up to 24 characters.
- See the Name Programming Chart for more.
3.
1815-01: DTMF Type [System: VoIP: Profile (1-4): Payload Types (1815): DTMF Type] on page 23
With the default DTMF Type (RFC 2833), there is a short burst of muted DTMF when the user
presses the
Open
and
Close
soft keys. If this is objectionable, change the DTMF Type to
SIP INFO
.