DSG Technology IP1200C, Operation Manual

Page: 22 / 48

20 Chapter 3 Configuring Your IP1200C
This item allows you to adjust the level of your transmitting volume. The larger number of level provides louder
voice for your receiver.
Step 1 At the prompt displays Select the option to setup: , input <7> and press ENTER to adjust the volume of
recording your voice.
Step 2 After the prompt displays New Record Volume (1-9, press ESC to exit):, input the level of volume <x>
from the range 1 to 9 and then press ENTER. The default setting is 5.
Step 3 Press any key to continue.
Prompt example:
If you would like to adjust your voice volume to 4, edit it as below.
Select the option to setup: 7
New Record Volume (1-9, press ESC to exit): 4
Press any key to continue...
Echo Cancellation
This item allows you to select the cancellation level of echo. With the higher level, you can reduce the echo.
Step 1 At the prompt displays Select the option to setup: , input <8> and press ENTER to adjust Echo
Cancellation.
Step 2 After the prompt displays New Echo Cancellation (0-2, press ESC to exit) :, input the level from the range
0 to 2 and then press ENTER. The default setting is 2.
Step 3 Press any key to continue.
Prompt example:
If you would like to adjust your echo cancellation level to be “1”, edit it as below.
Select the option to setup : 8
New Echo Cancellation (0-2, press ESC to exit) : 1
Press any key to continue ...
Busy Tone Setup
The busy tone signal is an indication of the end of a conversation or unavailability of the remote party. By tuning
the busy tone parameters, you can allow IP1200C to detect the busy tones more precisely for efficiently
disconnecting phone calls. This section covers the hang up issues associated with various regional POTS and PBX
systems interoperating with IP1200C.
At the prompt displays
Select the option to setup: , input <16> and press ENTER to edit. The prompt will show
the following 4 parameters and their default settings.
1) Busy tone cycles to hangup (2-9) : 4
2) Minimum busy tone length (100-1200 ms) : 200
3) Maximum busy tone length (100-1200 ms) : 600
4) Busy tone length tolerance (20-400 ms) : 80
1) Busy tone cycles to hangup
At the prompt Select item to setup (1-4, press ESC to exit): , input <1> and press ENTER to edit 1)Busy tone cycles
to hangup . Based on your phone system’s setting, select the number of busy tone rings from 2 to 9 for IP1200C to
disconnect the line after detecting the busy tone. Press ENTER to save.
The default setting is “4 “. That means after detecting continuous 4 rings of effective busy tone, IP1200C will deem
that the conversation comes to an end and will disconnect the line.
2) and 3) Minimum and maximum busy tone length