18 Chapter 3 Configuring Your IP1200C
The FXS interface provides connection to internal telephony equipment such as extension analog phone, modem
and a conventional PBX trunk-side. After you setup a password for FXS, access to IP1200C FXS ports will be
required to input the FXS password.
Step 1 At the prompt displays
Select the option to setup:
, input <13> and press ENTER to edit Password for FXS.
Step 2 After the prompt displays
New FXS Password (digits, press ESC to exit):
, input the password <xx...> and
then press ENTER.
Note:
The maximum length of the password is 10 digits. If you leave it as blank, anyone at the premise can access
to IP1200C without a password.
Prompt example:
If you would like to set a password for accessing FXS ports as 1234567890, input it as follows.
Select the option to setup : 13
New FXS Password (digits, press ESC to exit) : 1234567890
Press any key to continue ...
Telnet Password
You can configure or modify IP1200C settings using Telnet. This item allows you to limit the access of IP1200C
when use Telnet.
Step 1 At the prompt displays
Select the option to setup:
, input <14> and press ENTER to edit Telnet Password.
Step 2 After the prompt displays
New Telnet Password(digits, press ESC to exit):
, input the password <xx…>
and then press ENTER.
Note:
The default setting of Telnet password is 0000. The maximum length of the password is 10 alphabets or
digits. If you leave it as blank, anyone can configure IP1200C without a password.
Prompt example:
If you would like to set a Telnet password of configuring IP1200C as 1234567890, input it as follows.
Select the option to setup : 14
New Telnet Password (digits, press ESC to exit): 1234567890
Press any key to continue ...
Disable Telnet Function
You can disable the Telnet function of IP1200C not allowing anyone to configure the system settings from remote
PCs. Press the SECURITY button on the front panel of IP1200C to block the Telnet function. To enable the Telnet,
press the SECURITY button again to release it.
Port Configuration
This item allows you to enable, disable specific ports when they are broken. You can also view the duration of an
activated call and the total number of calls been connected after the power on.
Step 1 At the prompt displays
Select the option to setup:
, input <15> and press ENTER to edit Port
Configuration.
Step 2 The prompt will display the current setting of type, activity and status of all ports. At the prompt displays
Select entry to setup (1-8, press ESC to exit) :
, input the port number <x> you would like to configure
and then press ENTER.
Step 3 At the prompt displays
Port state (0: Disable, 1:Enable, press ESC to exit) :
, input <0> or <1> to disable or
enable the specific port and then press ENTER.
Step 4 The prompt will show the updated status of the specific port and the setting of all ports.
Step 5 If you would like to edit more ports, repeat step 2 to 3. Or press ESC to exit.
Prompt example:
Summary of Contents for IP1200C
Page 1: ...07I12CM ENC Voice Communication for Free High Performance Embedded VoIP Gateway...
Page 8: ......
Page 12: ......
Page 26: ......
