23
The following PC4010/PC4020/PC4020KT Menu Items are not used while programming telephone
numbers for LINKS operation. Do not select these items while programming telephone numbers for
LINKS operation, as adding pauses or the DTMF digits may result in improper dialing.
[2] Pause 2 Seconds
[4] DTMF
∗
[3] Pause 4 Seconds
[5] DTMF #
Transmission Cycle Days
Enter the number of days between test code communications. Valid entries are from
001 to 255; the default setting is 030.
Transmission Cycle Time
Enter the time of day for the test transmission. Enter the time in the 24-hour clock
format, where the first 2 digits are the hours ranging from 00 to 23, and where the
last 2 digits are the minutes ranging from 00 to 59. The default setting is 0000.
Links Trouble Reporting
Program Zone 1 trouble reporting code, and restoral reporting code.
PC5010/PC5015/PC1555/PC1565/PC5008/PC580/PC585 Control Panel
NOTE: The DSC PC5010/PC5015/PC1555/PC1565/PC5008/PC580/PC585 panel must be equipped with
software version 1.0 or later.
Programming the PC5010/PC5015/PC1555/PC1565/PC5008/PC580/PC585 for LINKS1000 Operation
Section [009]
LINKS Enable:
Program [16] into section 009. This will reserve the PGM1 output for LINKS1000
communications. Only PGM1 will support LINKS1000 operation.
Section [001]
LINKS Supervisory:
- [004]
Choose the zone that will be used to report the 24 hour LINKS1000 supervisory alarms
[section 001 to 004]. Program that zone as [09].
Downloading via LINKS1000:
If Downloading via cellular is to be used, choose a zone to perform LINKS Answer. Program
the chosen zone as [24]. This will force the panel to answer an incoming cellular call.
Section [320]
LINKS Trouble Reporting Code:
- [323]
In section 320 to 323, enter the desired reporting code for LINKS1000 Trouble reporting. Use
same zone as LINKS supervisory.
Section [349]
TLM Trouble Reporting via LINKS:
Go to section 349. Find TLM Trouble Code (via LINKS). Enter the desired reporting code. The
Restoral is contained in section 350, this will not be sent via the LINKS.
Section [352]
LINKS Test Transmission:
Program the LINKS Test Transmission code in section 352. The LINKS will follow the land line
test transmission schedule.
Section [361]
LINKS Call Direction Options:
- [368]
Go to sections 361 to 368. Determine which signal types will be sent via LINKS1000. Section
380, zone light [7] dictates whether the LINKS will be used as backup or primary
communications. When set to primary, the LINKS will always place a cellular call on signals
so identified in Call Directions.
