21
Automation Items
How to Program Automation Items
NOTE
: You need to program five sections for each Automation Item in use. Refer to the following list for
instructions on programming each section.
1
For each Automation Item, program a House Code and Unit Number. Default is [000]. (See Appendix A,
"X-10 House Code & Unit Numbers".)
2
For each Automation Item, program Miscellaneous Options. Options and defaults are described below:
Option Default
ON
OFF
01
OFF
Automation Item enabled
Automation Item disabled
02
ON
User Controlled ON/OFF
Not user controlled
03
OFF
Included in Global ON/OFF Command
Not included in Global ON/OFF Command
04
OFF
Dimming Enabled
Dimming Disabled
05
OFF
Follows Schedule ON/OFF Output
Follows Schedule ON/OFF Output
Condition Always
Condition only when Mode is ON
06
ON
Item is ON steady when active
Item activates for programmed time (program
the pulse time in sections [301] - [332])
07
ON
Item prompt: “ON/OFF”
Prompt is not “ON/OFF”
08
OFF
Item prompt: “OPEN/CLOSED”
Prompt is not “OPEN/CLOSED”
09
OFF
Item prompt: “Setback ON/Setback OFF” Prompt is not “Setback ON/Setback OFF”
3
For each Automation Item, program Schedule Assignments. Default is [OFF] for all schedules. From 1 to 16
schedules may be turned ON or OFF for each Item.
4
For each Automation Item, program Mode Assignments. Default is [OFF] for all modes. From 1 to 8
modes may be turned ON or OFF for each Item.
5
For each Automation Item, program a Timer / Output Condition. Enter one 2-digit number to determine how
the Automation Item will operate. Default is [00]. The following table lists the available options:
Option
Operation
00
Manual user control only
01
Follows Programmable Output Option Only
02
Follows Schedule Only
03
Follows Schedule
or
Programmable Output Option
04
Follows Schedule
and
Programmable Output Option
Select
only
one
firealarmresources.com
