5
®
Fig 6
Fig 5
Fig 7
TIP:
The drip tray and grill should be cleaned monthly.
WARNING:
Dispense water through the hot and cold
spigots before turning on the hot tank switch. Failure
to follow proper installation instructions may cause
damage to water dispenser.
Load water
bottle FIRST.
1
THEN turn on the
hot tank switch.
3
Dispense water
from hot and
cold faucets.
2
5. Before installing the new replacement cartridge, ensure that the seal is properly
installed on the inlet/outlet tube of the CrystalFlo water cartridge assembly as it
may have shifted during shipment or un-packaging.
6. Align the CrystalFlo water cartridge with openings in cooler (
Fig 5)
. With firm
pressure, push downward to lock the water cartridge into place. Ensure that
foam seal is pushed down and seals the reservoir completely.
7. Close the top cover by pushing down to lock into place
(Fig 6)
. If cover does
not close, check the CrystalFlo cartridge to make sure it is inserted completely.
8. Clean the cabinet, bottle receptacle and spigots with 70% rubbing alcohol or
disinfecting wipes. Vacuum or wipe the grill on the back of the dispenser to
remove any dust.
9. Clean the drip tray and grill by emptying the tray and cleaning the tray and grill
with dishwashing soap or by placing them on the top rack of the dishwasher
(Fig 7)
.
10. Wipe down the cooler and the surrounding area to dry any water spills.
11. Wash your hands thoroughly with soap and water for at least 20 seconds. Wipe
down new water bottle with 70% rubbing alcohol or disinfecting wipe and install
on the dispenser.
12. Dispense water through the cold and hot spigots to prime the water cooler.
Turn on the hot tank switch located at the rear of the dispenser.
