4
®
10. Now, plug dispenser into the power supply using a GFCI outlet.
11. Install drip tray and cover.
12. Prime water system. Place a cup under the dispenser faucet. To dispense hot water, depress the child safety lock (located
below the left hot faucet handle) simultaneously until water flows continuously. Next, depress the right cold faucet handle to
make sure there is a continuous flow of water.
NOTE:
It may take up to 1 minute to prime the hot tank, and up to 3 minutes to prime the cold tank.
13. Dispense water.
CLEANING AND SANITIZING
Your water dispenser exterior should be thoroughly cleaned at least twice a year, and your CrystalFlo water cartridge replaced every
12 months. If you do not have a replacement cartridge handy, you can order one
and it will be shipped directly to you.
Before you start cleaning, wash your hands thoroughly with soap and water for at least 20 seconds.
TIP:
The best time to replace your water cartridge and clean your dispenser is when the
existing water bottle is empty.
WARNING:
Always use caution when handling hot water.
• CrystalFlo replacement cartridge
• 70% rubbing alcohol or disinfecting wipes
• Clean cloth or soft brush
• Disposable non-latex gloves
• Bucket
• Heat-resistant container to fit under spigots
• Towels to absorb any water spills
WHAT YOU’LL NEED:
1. Turn off the hot tank heater switch
on the back of the dispenser and
unplug your unit
(Fig 1)
. Let the unit
stand for one hour before cleaning
to allow the hot tank to cool.
Fig 2
Fig 3
Fig 4
TIP:
Have a bucket nearby to dispose of the used
CrystalFlo cartridge, which will contain water.
3. Wearing gloves, press the cover lock
on the top rim of the cooler and pull
up to open
(Fig 3)
.
4. Pull CrystalFlo water cartridge upward to remove
(Fig 4)
. Do not squeeze
the water reservoir as water could leak out.
2. Place a glass or other container
below the water faucets to catch
any drips
(Fig 2)
.
Fig 1
