Parachute Manual DRS-M600_EN
©2021 Drone Rescue Systems GmbH
22/27
After initializing you must wait for the
state before you may take off. Right
after the takeoff you must check if the DRS has correctly detected the takeoff. Hover the UAV
above approx. 3 m over the ground for a few seconds and wait until the status LED switches
its mode according to
state and the buzzer beeps once. Only then the
automatic failure detection is active.
Caution:
If the DRS does not detect the takeoff, you must land the UAV because the automatic
deployment function is inactive. Switch the power off, wait 10 seconds and repeat
the start procedure. If the failure persists, inform Drone Rescue Systems GmbH or
it’s reseller and provide the logfile for failure analysis.
After flight
After each flight it is recommended to do a short visual overall inspection to see if any part or
component looks abnormal, worn out or broken. Replace damaged parts before using the UAV
the next time.
If you don’t use the parachute rescue system for a lon
ger period of time, we recommend to
take out the
and remove the tension from the
as described in chapter 9.
