This document and the information contained herein, is the exclusive property of Drivecon and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Drivecon.
Copyright © (2013) Drivecon. All rights reserved.
ENTER MENU MODE
1. Make sure that the stop button is pressed.
2. Press and hold button 8.
3. Pull out the stop button.
4. Release button 8.
Top LED flashes (green).
5. WITHIN 1 MINUTE FROM PULLING OUT THE STOP BUTTON:
Enter the code: 1-2-3-4 (button 1, 2, 3, 4).
LEDs 1, 2, 3, 4 (red) light up. If the entered code is invalid, the transmitter will switch off. When
the correct code is entered, top LED flashes (green), LEDs 1-4 (red) flash.
6. WITHIN 1 MINUTE FROM ENTERING THE CODE: Select the mode by pressing the buttons
according to the table:
1
Continuous/discontinuous mode
6
Load selection
3
Replace
8 (shift) + 6
Load bits at start-up
4
Show channel
7
Logout
8 (shift) + 4
Change channel
8
Shift
5
Auto shutdown
If no buttons are pressed within 1 minute, or the stop button is pressed in, the transmitter will exit the
menu mode and turn off.
NOTE! Button 8 = shift. To use shift:
1. Press button 8.
2. Press button 1-7.
3. Release button 1-7.
4. Release button 8.
13
Summary of Contents for PWR LYNK Series
Page 2: ......
