This document and the information contained herein, is the exclusive property of Drivecon and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Drivecon.
Copyright © (2013) Drivecon. All rights reserved.
CHAPTER 3: USER GUIDE
START THE TRANSMITTER
1. Pull out the stop button.
The transmitter top LED lights (green when the battery capacity is good, red when the battery
capacity is poor), LEDs 3 and 4 flash (red).
2. Press the start buttons (7, 8) at the same time, for at least 1 second.
3. Release the start buttons.
The top LED flashes green.
REGISTER THE TRANSMITTER IN THE RECEIVER
1. Start the transmitter.
2. Press function button on the receiver (LED 13 lights red).
3. Press the select button on the receiver (the relay LEDs light red).
4. Press button 1+2 on the transmitter that you want to register in the receiver.
5. The relay LEDs in the receiver flash 3 times when the transmitter is registered.
6. If the transmitter isn't found by the receiver within 10 seconds, the receiver will exit registration
mode and go back to normal operation.
ERASE THE TRANSMITTER FROM THE RECEIVER
1. Press the function button on the receiver (LED 13 lights red).
2. Press the select button on the receiver (the relay LEDs light red). KEEP PRESSED!
3. Release the select button when the red relay LEDs go out (approx. 4 seconds).
4. All registered transmitters have been erased from the receiver.
TURN THE TRANSMITTER OFF
1. Press the stop button.
NOTE! When the transmitter is active and the stop button is pressed, all relays go off.
12
Summary of Contents for PWR LYNK Series
Page 2: ......
