Drinkpod 1000 Pro Series, Installation Manual

Page: 39 / 67

Installing Your Water 1000 Pro Series
Installing Your Water 1000 Pro Series
2-37
Diagram 2.6.3-A - Screw Compression To Quick Connect Adapter Onto Port or Hose
acc.
1x
For 1 Accessory Appliance Configurations , you will need to run a section of
A
1/4 in. White PP Tubing from your Accessory Appliance, directly to where
you plan to locate your Drinkpod 1000 Pro Series (unless the appliance alread has an
integrated
Quick Connect Tubing hose you plan to use instead). Finish by
connecting the other
C
1/4 in. Quick Connect Shutoff Valve to the end of
the tubing or hose that will connect to your 1000 Pro Series. It should look like this:
acc.
1x
HOSE/PORT > ADAPTER (if necessary) > TUBING (if necessary) >
SHUTOFF VALVE (where Drinkpod 1000 Pro Series will be located)
Once you’ve completed this, jump ahead to
“Connecting Water Optimizer” on page
2-43 .
If your Accessory Appliance’s port or hose is Female Compression , use
D
1/4 in. Brass Compression Union to adapt the port/hose to the
1/4 in. White PP Tubing line (referenced above). Instructions for this are including in
the following step and “Diagram 2.6.4-B” on page 2-39 .
Extending
If your appliance has a port (rather than a hose), or a hose that will not reach sufficiently
far, follow the relevant directions below.