NOTE:
Wrapping the
Urosensor
™
in a paper handkerchief or tissue before
inserting it into the slit in the gusset can also help bedwetting to be detected more
quickly.
Using two pairs of underpants
1. Put on two pairs of close fitting underpants.
2. Insert the
Urosensor
™
™ in between both pairs of
underpants above the crotch area, near where the
urine will first escape.
NOTE:
Wrapping the
Urosensor
™
in a paper
handkerchief or tissue before inserting it between
the underpants can also help the bedwetting to be
detected more quickly.
Using a disposable diaper or pull-ups
1. With a sharp pair of scissors, cut a 25mm
(1 inch) slit in the absorbent layers on the inside
of the pull-up diaper near the area where the urine
will first escape.
2. With the point of the scissors, create a pocket for
the
Urosensor
™
to slide into.
3. Insert the
Urosensor
™
inside the pocket.
NOTE:
Make sure the
Urosensor
™
does not slide
down towards the back of the diaper or pull-ups away from the initial wetting
area.
NOTE:
As with the minipad, it is important the
Urosensor
™
is inserted under
some absorbent layers. However, disposable diapers tend to be highly absorbent
so wrapping the
Urosensor
™
in a paper handkerchief or tissue, and inserting it
between the body and the diaper can help the moisture reach the
Urosensor
™
before it is absorbed by the diaper. Diapers that include an absorbent gel layer
should be avoided as these will not result in sufficient moisture getting to the
Urosensor
™
to enable it to trigger.
