Dresser Series D Installation Supplement
© 2019 Natural Gas Solutions North America, LLC
Page 15 of 24
8.1.1
Preparing the AMR Bracket and Cable
After you remove the brackets, the pulse output
cable is visible as shown in Figure 18.
Figure 18: Pulse output cable on backside of meter
Loosen the cable gland and pull the cable until
at least 7.5–8 inches of cable extend from the
cable gland as shown in Figure 19. Retighten the
cable gland. Torque to 25–27 inch pounds.
Figure 19: Loosen cable gland and extend the cable
out of the gland
Flip one bracket over as shown in Figure 20, and feed the cable through the holes located at the bend
of the mounting brackets. Refasten the brackets to the meter as shown in Figure 21.
Figure 20: Properly positioned mounting bracket
Figure 21: Pull cable through the center hole
