Dresser Series D Installation Supplement
© 2019 Natural Gas Solutions North America, LLC
Page 14 of 24
Figure 14: Advanced screen in Dresser MeterWare
Figure 15: Leak Test Parameters screen in
Dresser MeterWare
Figure 16: Leak test pass/fail indications in Dresser MeterWare
8
AMR Installation
Perform the following steps to install an AMR (automatic meter reading) device, if applicable.
If an AMR is not factory installed, the AMR
mounting bracket will be attached as shown in
Figure 17. Remove the brackets before
installation.
Figure 17: AMR mounting brackets as shipped
from the Factory
•
If you have a pulse output cable visible under the AMR bracket (Figure 18), perform the steps in
Section 8.1.1.
•
If you have a pulse output cable circular connector visible under the AMR bracket (Figure 22), perform
the steps in Section 8.1.2.