Dream Maker Spas B6L Series, Owner'S Manual

Page: 9 / 26

7
Equipment System Operation
Initial Start-Up
From the moment your spa is plug in, it is automatically pre-set to
operate until it reaches 100
° F. This process could take up to 20 hours
depending on the initial water temperature. The spa is also pre-set to
filter the water for 4 hours per day (
F2
) and the clock starts the second
you plug it in.
Temperature Adjustment 60
°
F-104
°
F
When either of the “Accu temp pads ( ) are pressed once, the
LCD will display the temperature which has been set. Each time either
one of these pads are pressed again, the temperature will change by
1
°
F. After 5 seconds, the LCD will automatically display the current spa
temperature.
Jets
Press the pad to run the high speed pump on and off. If left running,
the pump will automatically turn off after 15 minutes.
Light
Press the pad to turn the spa light on and off. If left on, the light will
automatically turn off after 4 hours.
Spa Water Maintenance
This function enables you to program the amount of water filtration
time.
Press or and then to enter the programing mode.
Once in the programing mode press or to select the filtration time.
F2
In this mode the water will be filtered for 4 hours every day.
F4
In this mode the water will be filtered for 8 hours every day.
F6
In this mode the water will be filtered for 12 hours every day.
FC
In this mode the water will be filtered continuously.
To exit press
Standby Mode
This function allows you to disable the equipment when the filter needs
to be serviced without disturbing the already programed filtration time.
Press or and then to enter the standby mode. All spa functions
are disabled except for freeze control. To exit from standby press any button.
WARNING: SHOCK HAZARD! NO USER SERVICEABLE PARTS. Do not attempt to service this control. Contact your dealer or service
center for assistance. Follow all owner’s manual power connection instructions. Installation must be performed by a certified licensed
electrician and all grounding connections must be properly installed.
WARNING
OPERATING THE SYSTEM WITHOUT WATER
WILL CAUSE SEVERE DAMAGE
Display Messages
OH
“Overheat” (spa is deactivated)
DO NOT ENTER THE WATER. If the spa water has reached
108
° F (44 ° C), Remove the spa cover to cool the water. The spa
will remain shut down until the water and the heater sensor cools
to 104
° F. At that point press any button to reset the spa. If the
spa will not reset, shut off the power to the spa and call your
dealer or service organization.
SN
“Non Functional High Temp Sensor” (heater is
deactivated)
Open sensor. Call your dealer or service center.
B6XH Series Control
REFER TO ID PLATE ON FRONT OF
SPA FOR SERIES NUMBER