Vigor2100 Series User’s Guide
59
Enable
Check this box to invoke this setting.
Prefix Number
The phone number set here is used to add, strip, or replace the OP
number.
Mode None
- No action.
Add
- When you choose this mode, the OP number will be added
with the prefix number for calling out through the specific VoIP
interface.
Strip
- When you choose this mode, the OP number will be deleted
by the prefix number for calling out through the specific VoIP
interface. Take the above picture (Prefix Table Setup web page) as
an example, the OP number of
886
will be deleted completely for the
prefix number is set with
886
.
Replace
- When you choose this mode, the OP number will be
replaced by the prefix number for calling out through the specific
VoIP interface. Take the above picture (Prefix Table Setup web page)
as an example, the prefix number of 03 will be replaced by 8863. For
example: dial number of “031111111” will be changed to
“88631111111” and sent to SIP server.
OP Number
The front number you type here is the first part of the account
number that you want to execute special function (according to the
chosen mode) by using the prefix number.
Min Len
Set the minimal length of the dial number for applying the prefix
number settings. Take the above picture (Prefix Table Setup web
page) as an example, if the dial number is between 7 and 9, that
number can apply the prefix number settings here.
Max Len
Set the maximum length of the dial number for applying the prefix
number settings.
Interface
Choose the one that you want to enable the prefix number settings
from the four pre-saved SIP accounts (including PSTN).
3
3
.
.
6
6
.
.
2
2
S
S
I
I
P
P
A
A
c
c
c
c
o
o
u
u
n
n
t
t
s
s
In this section, you set up your own SIP settings. When you apply for an account, your SIP
service provider will give you an
Account Name
or user name,
SIP Registrar, Proxy,
and
Domain name
. (The last three might be the same in some case). Then you can tell your folks
your SIP Address as in
Account Name@ Domain name
As Vigor VoIP Router is turned on, it will first register with Registrar using
AuthorizationUser@Domain/Realm. After that, your call will be bypassed by SIP Proxy to the
destination using AccountName@Domain/Realm as identity.
Note:
Vigor VoIP router supports three SIP accounts from firmware version 2.5.9
and later.
