2
FIG.
(1.1)
(13)
(9)
(16.1)
− To secure on each side, tighten the supplied screw
through the hole situated inside the rear wheel
housing
(16.1)
and on through into the hole in the
tubular frame of the handle
(13)
.
6.2 FITTING THE REAR WHEELS
– FIG. 3
− Using one end of the wheel axle
(33)
, pass one of
the 2 wheel locking pins
(30)
through the hole at the
end of the axle. Assemble making sure that it is the
correct way around as shown.
− Pass the opposite end of the axle
(33)
through the
open end of the moulded bracket situated inside the
wheel housing
(16.2)
, and out through to the other
side of the machine.
− Repeat assembly on the opposite side. Snap-fit the 2
wheel hub caps
(31)
in place to complete the rear
wheel assembly.
3
FIG.
(33)
(32)
(32)
(16)
(16.2)
(30)
6.3 FITTING THE CASTORS – FIG. 4
− Snap-fit the 2 castors
(15)
into the holes located on
the machine base to complete the assembly.
4
FIG.
(15)
7. VACUUMING DRY DUST
AND DIRT
7.1 CHANGING SETUP FROM WET TO
DRY VACUUMING – FIGS. 5 - 6
Empty the tank and dispose of any liquid which may
have been picked up previously.
Remove the anti-foam filter
(28)
(if fitted) and fit cartidge
filter
(27)
.
5
FIG.
(28)
6
FIG.
(27)
Note: The cleaner comes complete with a cleanable
cartridge filter
(27
). The cartridge filter should be
cleaned using a soft brush at regular intervals. This will
– 7 –
