DR 372111, Safety & Operating Instructions Manual

Page: 32 / 44

32 3-POINT HITCH
DR
® SELF-FEEDING™ CHIPPER
OPERATION
Adjusting the Extended Top-Discharge Chute Discharge Direction:
1. Pull the Hitch Clip and remove the Locking Pin (Figure 48).
2. Rotate the Extended Top-Discharge Chute to the direction desired.
NOTE: The Extended Top-Discharge Chute has a range of motion of 180 ˚ that spans
the front and both sides of the Chipper. There are 11 different hole settings at 18 ˚
increments that you can use.
3. Line up the Locking Pin hole to the closest hole setting in the Discharge
Ring.
4. Install the Locking Pin and secure it with the Hitch Clip.
Adjusting the Deflector Direction:
1. Grab the Deflector Handle and rotate the Deflector to the desired discharge
position (Figure 49).
MAINTENANCE
Tools and Supplies Needed:

All Purpose Grease
Lubricating the Extended Top-Discharge Chute:
1. Pull the Hitch Clip and remove the Locking Pin from the Discharge Ring
(Figure 48).
2. Apply some all-purpose grease in each hole of the Discharge Ring and
Center Ring as you rotate the Chute.
3. Rotate the Extended Top-Discharge Chute for the full 180 ˚ of rotation for a
few times to spread the grease inside the Discharge Ring.
4. Reposition the Extended Top-Discharge Chute to the desired angle and
insert the Locking Pin and Hitch Clip.
Deflector
Figure 49
Deflector
Handle
Higher
Discharge
Lower
Discharge
Locking
Pin
Figure 48
Hitch
Clip
Extended Top-
Discharge Chute
180°
Discharge
Ring