DR 372111, Safety & Operating Instructions Manual

Page: 31 / 44

CONTACT US AT
www.DRpower.com
31
Chapter 6: Chipper Accessories
Extended Top-Discharge Chute
The Extended Top-Discharge Chute enables you to better control the direction
of the discharged chips and allows you to direct them into a trailer or truck bed
for transport.
Tools Needed:

Two 1/2" Wrenches
INSTALLATION
1. Remove the two Bolts and Locknuts from the Low Discharge Assembly with
two 1/2" wrenches
(Figure 46).
2. Remove the Low Discharge Chute from the Chipper.
3. Position the Extended Top-Discharge Chute onto the Chipper with the
Locking pin on the outside (side furthest away from the hopper)
(Figure 47).
4. Install the two Bolts and Locknuts and tighten with two 1/2" wrenches.
Figure 46
Low
Discharge
Chute
Bolts and
Locknuts
Extended
Top-
Discharge
Chute
Figure 47
Locking
Pin
Bolt and
Locknut
(2 places)
Disengage PTO, shut down the tractor engine, remove the key, wait for all moving parts to come to a complete stop, disconnect
the PTO shaft from the tractor, then wait 5 minutes before performing any maintenance procedure or inspection on the chipper.