8 0 0 H I N E S B U R G R O A D , S O U T H B U R L I N G T O N , V E R M O N T 0 5 4 0 3
©2019 DR Power Equipment. All rights reserved
A0000121610_A
Daily Checklist for the DR WALK BEHIND BLOWER
To help maintain your DR WALK BEHIND BLOWER for optimum performance, we recommend you follow this checklist each
time you use your machine.
[ ] Check the engine oil level.
[ ] Check Fuel Level
[ ] Check the general condition of the machine, e.g.; nuts, bolts, welds, etc.
[ ] Check and clean Engine Fins and controls of Debris.
End of Season and Storage
If your machine will be idle for more than 30 days, we recommend using a gas stabilizer. This will prevent sediment from
gumming up the Carburetor. If there is dirt or moisture in the gas or tank, remove it by draining the tank. Completely fill
the tank with fresh, unleaded gas and add the appropriate amount of stabilizer or gasoline additive. Run the Engine for a
short time to allow the additive to circulate.
Change Engine Oil.
Clean dirt and debris from the Cylinder Head Cooling Fins and Muffler area of the Engine.
Remove the Spark Plug and pour about 1 ounce of motor oil into the Cylinder hole. Replace the Plug and pull the Recoil
Starter Rope until you feel strong resistance. This will coat the piston and seat the valves to prevent moisture buildup.
Empty and clean the Debris Bag and ensure it is dry. Remember, decomposing material generates heat and could start a
fire.
Clean or replace the Air Filter.
Clean the exterior of the unit to remove all dirt, grease, and any other foreign material. To prevent rust, touch up painted
surfaces that have been scratched or chipped.
For Electric-Start models, store the Battery in a dry area that will not freeze. If you will not use the machine over a long
period, charge the Battery every four to six weeks.
If possible, store the machine in a dry, protected place. If it is necessary to store the machine outside, cover it with a
protective material (especially the Engine and Housing).
Before performing any maintenance procedure or inspection, stop the engine, wait five minutes to allow all parts to cool.
Disconnect the spark plug wire, keeping it away from the spark plug.
Before performing any maintenance procedure or inspection, stop the engine, wait five minutes to allow all parts to cool.
Disconnect the spark plug wire, keeping it away from the spark plug.
