10
DR
®
WALK BEHIND BLOWER
Adding Engine Oil and Gasoline
Adding Oil
1.
Remove the Oil Fill/Dipstick from the right hand side of the engine and wipe
the Oil off using a clean Rag (
Figure 6
).
2.
Fill the engine with Oil until the Oil level is about a 1/4" below the top of the
oil fill opening.
Note:
Add oil slowly and wait several minutes for oil to settle before rechecking oil
level.
3.
Insert the Oil Fill/Dipstick but do not screw it in.
4.
Remove the Dipstick and check the Oil level. Add oil as needed for correct
level.
5.
Replace and tighten the Oil Fill/Dipstick when finished.
Adding Gasoline
1.
Remove the Cap from the Fuel Tank and insert a clean Funnel (
Figure 6
).
2.
Fill the fuel tank with fresh, clean Gasoline to 1 inch below the bottom of the
filler neck to provide space for any fuel expansion.
3.
Reinstall the Fuel Fill Cap securely and wipe up any spilled gasoline.
Connecting the Battery (electric start models)
1.
Install the Negative (Green) Battery Wire onto the Negative Battery Terminal
(
Figure 7
).
Battery
Figure 7
Negative
(Green) Wire
Oil
Fill/Dipstick
Figure 6
Fuel Fill Cap
You must add oil before starting the engine. This machine is shipped without
oil. Traces of oil may be in the reservoir from factory testing, but
you must
add oil before starting the engine
. Fill the reservoir slowly, checking the level
frequently to avoid overfilling.
