CONTACT US AT
www.DRpower.com
15
Spacer
Drive Pulley
Assembly
Figure 21
Bolt
Link Belt
Engine Pulley
Replacing the Belt (Pro Models)
Tools and Supplies Needed:
1/2" Wrench
3/8" Wrench
10mm Wrench
13mmWrench
Small Locking Pliers
Diagonal Cutters (or equivalent)
New DR Linked Belt
Needle Nose Pliers
Removing the Old Belt
Note:
The machine can be carefully tipped back onto the Handlebars for better
access underneath. You must move the Lateral Airflow Lever to the side
before tipping the machine back.
1.
Remove the two Bolts that secure the Belt Cover using a 1/2" Wrench and
remove the Cover (
Figure 18
).
2.
Remove the two Bolts that secure the Front Cover using a 3/8" Wrench and
remove the Cover (
Figure 19
).
3.
Remove the two Bolts that secure the Pivot Stop Rod using a 10mm Wrench
and slide the Rod out of the Spring end as you remove the Rod (
Figure 20
).
4.
Remove the two Bolts that secure the Drive Pulley Assembly using a 13mm
Wrench (
Figure 21
).
Note:
You may need to use small Locking Pliers to hold the Rod from turning while
the Bolts are being removed.
5.
Rotate the Drive Pulley Assembly sideways and lift up to relieve tension on
the Belt. Remove the Belt from the bottom of the Drive Pulley.
6.
Let the Drive Pulley Assembly rest inside the Frame.
Note:
Ensure that the Spacer that is on the left side of the Drive Pulley Shaft stays
in place for installation.
Pivot
Stop Rod
Figure 20
Bolt
Spring
Pivot Stop Rod
Front Cover
Figure 19
Bolt
Bolt
Figure 18
Belt Cover
