Mach M5
Dr. Mach
Lamps and Engineering
4.2.2 Changing the filter disk
The filter disk between reflector and protective disk
prevents a damaging heating of the illuminated area.
ATTENTION!
The lamps must not be used without this filter.
Always place the filter disk on a soft, non-
scratching base to preserve its surface.
To change the filter disk proceed as follows:
•
Turn off the lamp.
ATTENTION: Parts of the housing and the
halogen bulb may be very hot immediately af-
ter use.
•
Turn the lamp, so the light outlets point to the
ceiling.
•
Turn
screw 1
anticlockwise with an appropriate
screw driver.
Remark:
In case there is no screw driver available, you
can use a coin.
•
By turning the
screw 1
anticlockwise, the
optic
ring 2
turns clockwise off the lower housing part.
•
Remove the
optic ring 2
by pulling it upwards
.
1
2
59270001
Edition 06
28.09.2004 / Bak page 15/26
