17
6.0
Safety instructions
Attention
The units must be attended when in use. Disconnect the mains plug and
check that the switch is disabled,
-
if the units remain unattended
-
during assembly and disassembly
-
in the case of a voltage dip (below 200V or below 340V),
-
if the mains voltage fluctuates (phase imbalance) or in case of interruption of a phase (phase
failure),
-
For adjusting or fitting an accessory.
Switch the machine off if you stop operation for any reason. This prevents the unit from suddenly starting
when unattended.
Do not use the unit when
-
a part of the housing is missing or defective,
-
there is damage to switches, lines, or plug connections (daily inspection!)
-
When operating the units, cooling water must not penetrate the electrical components in whichever
location the units are used.
-
If water is dripping from the unit, stop work and take the unit to an authorised service centre.
-
After a break in operation, only switch on again if the saw blade or drill bit can rotate freely.
-
Check the work area with a pipe detector in order to avoid cutting into electrical cables, water
pipes, or gas pipes etc.
Summary of Contents for 102405
Page 2: ...2...
Page 20: ...20 10 0 Spare parts lists 10 1 Powerbox PB RX SX 12...
