DPS Telecom RPS AB6, User Manual

Page: 53 / 74

49
You may set a Description for each power output, A1-B6, in the appropriate field.
The checkboxes labeled 1-8 correspond to your Remote Power Switch's 8 notifications (labeled 1-8 in the ID column
of the Notifications screen). Toggle the checkboxes to determine which notifications you would like sent for each
feed.
Click Details to reveal additional settings for each output:
Field Description
Reset Time Indicates the length of time between power-off and power-on when resetting equipment
attached to that particular power input.
Power on state The state of the power output when a user restores power to the Remote Power Switch
(i.e. resetting the unit or flipping the breaker switch associated with a power output).
Valid options are
On , Off , or Last State (which causes the output to revert to the state
it was in when the unit lost power).
Power on order Determines the order in which power is delivered to the power outputs when powering
on or resetting the Remote Power Switch. For each output, choose the order, 1st
through 12th. If you wish to remove or rearrange the power on order, you can click
Unorder All to set all power outputs back to Unordered .
Low Voltage Disconnect Check to enable the Low Voltage Disconnect feature. See the following section for
details about the Low Voltage Disconnect Feature.
Power Off Voltage The measured input voltage at which the RPS will shut off the output
Power On Voltage The measured input voltage at which the RPS will restore power to the output