Doyon FC18GEU, Instructions Manual

Page: 28 / 65

A-26
BEFORE CALLING FOR SERVICE
ANSWERS TO MOST FREQUENT QUESTIONS
Questions Solutions
The oven is "ON", but does not function.
•
Check the main breaker (the one on the
building panel) and also the breaker located
at the front of the oven (5 amps).
The fan runs but the oven does not heat.
The red light on the front control panel is on
and the alarm rings.
•
Check if the thermostat is adjusted high
enough to fire the oven.
•
Check the main gas valve.
•
To start it over, press the red button on the
front control panel for 2 seconds. The burner
will start up (you can hear it). You can
repeat this operation three times. If it does
not start up again, contact our company or a
certified gas technician.
The oven heats too much or does not
produce enough heat.
Measure the temperature with an oven
thermometer and compare it with the
temperature indicated on the thermostat.
The conveyor chain is not tight enough. To tighten:
•
Take off the protector at the end of the speed
control located on the sides of the conveyor.
With a 7/16" key, lightly unscrew the 2
screws having an adjustment on each side;
•
Tighten the belt of the conveyor and the
screws;
•
Put back the protectors.
The conveyor does not turn.
•
Check the 0.75 amps breaker on the front
for FC2GEU or on the side for FC18GEU of
the oven.
•
If the breaker is "tripped", check if the
conveyor is free from any obstructions
before resetting the breaker.
•
Check the conveyor main shaft if the
security clutch is not slipping.
TROUBLESHOOTING