![Doyon FC18GEU Instructions Manual Download Page 10](http://html.mh-extra.com/html/doyon/fc18geu/fc18geu_instructions-manual_2525398010.webp)
A-8
To adjust the SP value, you just have to press the left key and use the up and down keys to set
temperature value. Press the left key to return to run mode.
FAULT DESCRIPTION
When there is a fault, a buzzer rings and the red light "fault" turns on
It may be caused by
•
Too much pressure in burner compartment (blower does not work or does not produce
vacuum) air pressure switch is not well adjusted or defective.
•
Gas pressure is too low or not well adjusted or defective gas pressure switch.
•
Malfunction of ignition system or detection of flame.
To correct it, wait 10 seconds and press the red push button "fault" (same one as the "fault" light).
If the fault is still active and cannot be reset, call for service.
Cooling fans
Two cooling fans run during normal operation of the oven.
A temperature detector (thermodisk) is installed in the control compartment to start the three
cooling fans when the temperature rises over 110 °F.
Summary of Contents for FC18GEU
