Doyon FC18GEU, Instructions Manual

Page: 21 / 65

A-19
INSTRUCTIONS TO REVERSE DIRECTION OF THE
CONVEYOR ON FC2GEU
(See drawings and pictures on the following pages)
NOTE: In order to reverse the FC2 conveyor, it's necessary to be two persons.
1- Place the main switch to the position "OFF". (A)
2- Make sure that the oven has cooled down completely.
3- Disconnect the conveyor. (Unscrew the conveyor plug) (B)
4- Remove the two plates located under the conveyor. (C)
5- Take out the screws which holds the end finishing plate and the two side finishing plates
of the conveyor (D) and remove these plates. (E)
6- To take out the conveyor, it takes two persons, one at each end. The person who is at the
opposite end of the conveyor motor gearbox of the conveyor raises it 1" (2.5 cm) (F) and
pushes it through the oven (G). When the end of the conveyor is inside of the oven, it is
preferable that the same two persons place themselves on each side of the conveyor and
continue to pull with precaution to take out the conveyor completely.
7- To reinstall the conveyor, enter it at the opposite end and repeat the above instructions in
reverse.