Dot Hill Systems AssuredSAN 6004, Cli Reference Manual, Page: 160 / 363

160 Alphabetical list of commands
Elem Status
A standard SES status for the element:
•
Disabled
: Critical condition is detected.
•
Error
: Unrecoverable condition is detected. Appears only if there is a firmware problem related
to PHY definition data.
•
Non-critical
: Non-critical condition is detected.
•
Not Used
: Element is not installed in enclosure.
•
OK
: Element is installed and no error conditions are known.
•
Unknown
: Either:
• Sensor has failed or element status is not available. Appears only if an I/O module indicates
it has fewer PHYs than the reporting I/O module, in which case all additional PHYs are
reported as unknown.
• Element is installed with no known errors, but the element has not been turned on or set into
operation.
Disabled
•
Enabled
: PHY is enabled.
•
Disabled
: PHY is disabled.
Reason
• Blank if
Elem Status
is
OK
.
•
Error count interrupts
: PHY disabled because of error-count interrupts.
•
Phy control
: PHY disabled by a SES control page as a result of action by a Storage
Controller or user.
•
Not ready
: PHY is enabled but not ready. Appears for SC-1 PHYs when the partner I/O
module is not installed. Appears for Drive, SC-1, or Ingress PHYs when a connection problem
exists such as a broken connector.
•
Drive removed
: PHY disabled because drive slot is empty.
•
Unused - disabled by default
: PHY is disabled by default because it is not used.
•
Excessive Phy changes
: PHY is disabled because of excessive PHY change counts.
Example Show expander status for each enclosure.
# show expander-status
Basetypes • sas-status-controller-a
• sas-status-drawer
• status
See also • clear expander-status
• set expander-fault-isolation
• set expander-phy