9
charging anD loaDing the li ion
battery
First remove the Li-Ion battery. Unlatch
the battery by pressing the two lateral
buttons simultaneously. Now lift the
battery upwards.
Connect the charger to the battery and to mains supply. The charger will indicate the charging status. A red LED glows during
charging process. Once the battery is fully charged, a green LED will glow. Now you can insert the battery into the fl ash housing.
It will click closed, once in correct position.
DisPlay oF charging status
When the fl ash unit is switched on, fi ve LEDs will indicate the battery status. If all
fi ve LEDs glow, the battery is charged at 100%. Each LED represents a capacity
of approx. 20%. If only one LED glows (status 20%), we recommend to charge or
replace the battery.
rePlacement battery
We recommend purchasing a replacement Li-Ion battery, item no. 371321 for your mobile studio fl ash DMF-480.
So you will not run out of energy “on location”.
Working with the DMF-480 Mobile Studio Flash with Battery
mounting the Flash unit
The
integrated handle
is comfortable to hold and allows an assistant to align the fl ash.
B. To adjust the
tilt angle of the fl ash
,
release the „Lock“ screw. Set the
desired tilt angle and tighten the
screw again (Figure 3).
C. Additionally, the handle has an
umbrella holder. Before mounting an
umbrella remove the fl ash refl ector
fi rst. Then slide the umbrella rod
through the opening and tighten the
mounting screw (Figure 4).
A. You will fi nd an
integrated mount for
light stands
in the handle. To mount
the fl ash onto a light stand, release
the mounting screw on the bottom
of the handle (Figure 1). Now the
fl ash can be placed onto the light
stand. For secure hold screw in the
mounting screw into the thread on
rear side of the handle (Figure 2).
1
3
4
2
3
4
