Dormakaba ED250, Installation Instructions Manual

Page: 5 / 82

5 ED250 08-2018 DL4614-070
dormakaba ED250 IG Installation Instructions Table of Contents
16 In-ground case installation 43
16.1 Verify concrete floor blockout 43
16.2 Install cement case, single door 43
16.3 Install cement cases, double door 44
16.4 Locate center of cement case spindle 45
16.5 Reinstall cement case cover 47
16.6 Anchoring cement pour in blockout around
bottom one inch of cement case 47
16.7 Remove cement case cover. 48
16.8 Single door, install and terminate 115 Vac
liquidtight conduit and wiring 48
16.9 Double doors, install and terminate
115 Vac liquidtight conduit and wiring 49
16.10 Single door, install PVC reducer fitting
and PVC pipe 50
16.11 Single door, route accessory wiring into
cement case 50
16.12 Double doors, install PVC reducer fittings
and PVC pipe 51
16.13 Double doors, route accessory wiring into
cement cases 51
16.14 Double doors, install case to case 115 Vac
cable 51
16.15 Rotate cement case spindle to enable
door hanging 52
16.15.1 Set braking circuit plug position 52
16.15.2 Set AS installation type parameter 53
16.15.3 Initiate learning cycle to rotate spindle
to door hanging position 54
16.16 Set operator spring tension 55
16.17 Install program switch panel
Install RJ45 plate assembly (double doors
only) 55
16.18 Hang door 56
16.19 Reinstall cement case cover 57
16.20 Final anchoring cement pour 57
16.21 Remove cement case cover for ED250
commissioning 57
16.22 Cement case chain tension 58
16.23 Cement case spindle height adjustment 59
16.24 Spindle centering 60
17 Measure door width, set reveal depth 62
17.1 Door width parameter Tb 62
17.2 Tb parameter values 62
18 Set reveal depth 62
18.1 Reveal depth parameter rd 62
18.2 rd parameter values 62
19 Power fail closing speed 63
19.1 Set power fail closing speed 63
20 Parameters 64
20.1 Parameters 64
21 Single door first commissioning 67
21.1 First commissioning 67
21.2 Set configuration parameter 68
21.3 Verify driving parameters for low energy
operation 69
21.3 Perform learning cycle 70
22 Double door first commissioning 71
22.1 Separately commission active and passive
doors 71
22.2 Set operator parameters for double door
operation 71
22.3 Connect communication cable between
operators 72
23 Connect accessory wiring 73
23.1 Connect accessory wiring, single door 73
23.2 Connect accessory wiring, double doors 73
24 ANSI/BHMA standards 74
24.1 A156.19 Low energy power operated
doors 74
25 Install cement case cover 76
25.1 Install cement case cover 76
26 Install door threshold 77
26.1 Install door threshold 77
27 Install door signage 77
27.1 Install door signage 77
28 Upgrade cards 78
28.1 Upgrade cards 78
28.2 Container module 78
28.3 Installing upgrade cards 79
Appendix A - Wiring diagrams 80
A1.1 DX4604-21C Key Switch Panel with
RJ45 connector
80
A2.1 DX4604-11C Key Switch Panel 81