BFP SYSTEM :
Quick Starting Guide
4. SOFTWARE
4.1. Load configurations files
If a configuration already exist, you may load the configuration by clicking Load Configuration buttons in
the LED driver and the BFP driver tabs (2 different files).
4.2. Set LED driver
Turn ON the LED Driver, and set each channel to TTL by pushing the knob 2 times, then adjust the
current to the desired value by rotating the knob.
* You may also select the TTL mode and set the LED current using the software by clicking Add Channel
in the Configuration Tab as per figure below.
In order to set the excitation power, you need to monitor the optical power output from the optical fibre
cable that would connect to the sample (animal) with an optical power meter (i.e. Gentec-EO model
PRONTO-Si). Initial current adjustment could be made by setting the LED in continuous mode 'CW',
then calculate the average excitation power in experiment by divising by 2 if using 2 sources interleaved,
or by 3 for 3 sources interleaved.
Copyright © 2020 Doric Lenses Inc. All Rights Reserved.
6 / 15
