Outside
Outside
Outside
See "FRAME PREPARATION" on page 9 for cut-out and holes.
After preparing, install top strike into door frame and mount
with two(2) strike screws.
DXAS216 Strike
Strike
Screws
Release Plunger
Plunger Screws
Shim (if using)
P
E
Connector
L
Retractor
1. Deadbolt should be extended.
2. Pass side screws (1) through support bracket, connector
and retractor, then tighten the screw.
3. Fasten screws (2). through support bracket on retractor.
Note: Fasten screws (2), then adjust deadbolt before tighten them
1
2
1
1
1
2
2
2
Support
Bracket
Adjustment Screw
Screws
M
11. HANG DOOR AND INSTALL TOP STRIKE &
RELEASE PLUNGER
10. INSTALL ROD SIDE SCREWS
Pullman Latch
(Default)
Round Bottom Latch
(Option)
2. Attach cover to center case with two(2) center case screws.
1.For Rod Adjustments SEE PAGE 9
Cover Screws
I
Cover
13. ADJUST RODS AND INSTALL CASE COVER
12. INSTALL BOTTOM STRIKE
8 / 12
DXAS227
N
O
E
DXAS225
DXAS226
Mark fand prepare floor according to the type of strike and fastener
furnished as per illustrations below. Thresholds will have to be modified
to accommodate strike. For floor strikes not shown, please refer to the
installation instructions for those stikes.
See Page 10 for details.
See "FRAME PREPARATION" on page 9 for holes.
After preparing, install release plunger wih two (2) plunger
screws. Ensure hole in door aligns with plunger pin (see
page 6.)