Doosan LIGHTSOURCE V9, Operation And Maintenance Manual

Page: 23 / 66

OPERATING INSTRUCTIONS
19
LIGHTSOURCE V9
UNIT SHOWN WITH MAST IN
TRANSPORT POSITION
MAST OPERATION
WARNING: Check that no person is behind the machine (within
10m) while the tower is raised or lowered.
Check that no obstruction is overhead.
Before operating the mast, inspect the cable for damage. Replace
damaged cables if necessary.
Before and during all mast operation, ensure the area is clear of
persons and obstructions within a 2m radius.
When the mast has completed its normal travel, or is prevented
from travelling, immediately release the control switch, to avoid
cable overtension.
Raising the tower
1. Start the engine.
2. Use the mast control switch to raise the tower.
3. Lift the pin [2] to rotate tower. Release the pin after rotating the
tower to the desired position.
Lowering the tower
1. Start the engine.
2. Switch the lamps off.
3. Lift the pin [2] to rotate tower. Release the pin after rotating the
tower to the desired position.
4. Make sure that the pin has engaged and locked the tower in
position.
5. Use the mast control switch to lower the tower to transport
position.
TOWING
WARNING: Make sure that the tow vehicle has a towing capacity
of the weight of this unit as stated in “GENERAL INFORMATION ”
section of this manual.
NOTE: This unit is equipped with a mast lowering switch, when parking
brake is released, to avoid towing with raised mast.
WARNING: Beware of lamps lowering when operating under mast
area.
1. Connect the machine to the vehicle.
2. Rotate the lamps to transport position and secure by fitting straps
[1] around the lamp bodies.
WARNING: The lamp bodies may be HOT.