Doosan LIGHTSOURCE V9, Operation And Maintenance Manual

Page: 16 / 66

SAFETY
12
LIGHTSOURCE V9
Store the front outriggers and all jacks. To secure each jack handle,
wrap the jack positioning pin chain around the handle to keep it from
being damaged during towing.
Towing
CAUTION: Do not tow or move with mast extended.
Do not tow this unit with a vehicle whose towing capacity is less than
the unit gross weight shown in General Data.
Do not exceed maximum speed of 80km/h (or local legal maximum,
if lower) when towing unit.
Welding
Prior to any welding, disconnect alternator relays, voltage regulator,
meters, circuit breakers and battery cables. Open all circuit breakers,
and remove any external connections. Connect the welding ground as
close as possible to the area being welded.
Mast Operation
Before and during all mast operation, ensure that the area is clear
of persons and obstructions over a 2m radius. When the mast has
completed its normal travel, or is prevented from travelling, immediately
release the control switch, to ensure that no cable overtension occurs.
Check that no person is behind the machine (within 10m) while the
tower is raised or lowered.
The unit must have all outriggers extended and be level before
raising mast.
DO NOT climb on tower. Perform repairs and adjustments with the
tower in the down (transport) position.
Damaged cables may break during tower operation allowing the
tower to fall. Do not operate tower with damaged cables. Replace
damaged cables.
Lamps
Inspect lamps and replace broken or missing lamp lens or
punctured glass bulbs. Do NOT operate lights with broken or missing
lens or broken glass bulb.